- Thread starter
- #81
Typhon Come check out my youtube channel guys :)
- Thread starter ChriswithaC
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Thread starter
- #82
- Thread starter
- #83
- Thread starter
- #84
- Thread starter
- #85
- Thread starter
- #86
- Thread starter
- #87
- Thread starter
- #88
- Thread starter
- #89
Last edited:
- Thread starter
- #90
- Thread starter
- #91
- Thread starter
- #92
- Thread starter
- #93
- Thread starter
- #94
- Thread starter
- #95
- Thread starter
- #96
- Thread starter
- #97
- Thread starter
- #98
- Thread starter
- #99
JRG4ARRMA
Member
- Messages
- 37
- Reaction score
- 88
- Arrma RC's
- Kraton 4s
Hey ChriswithaC!
I just watched your YT video from two months back regarding ESC problems on your K4S V2.5. Did you ever solve the problem? My issue is similar. The truck won’t power on. Pressing the power button immediately sets off a red blinking light and no throttle or brake. Fans run and steering works. Using brand new gensacearespammers 100C 5300 mAh LiHv. Arrma told me that HiLv was no problem for the ESC-even though the manual says 14.8v maximum. No temperature problems. Sometimes everything works fine and other times nothing but the red light of failure
. If it’s a firmware update issue, can you please explain what I need to do that and what the process is?
Thanks also for your video on setting the endpoints. I didn’t know that until the second pack!!
I just watched your YT video from two months back regarding ESC problems on your K4S V2.5. Did you ever solve the problem? My issue is similar. The truck won’t power on. Pressing the power button immediately sets off a red blinking light and no throttle or brake. Fans run and steering works. Using brand new gensacearespammers 100C 5300 mAh LiHv. Arrma told me that HiLv was no problem for the ESC-even though the manual says 14.8v maximum. No temperature problems. Sometimes everything works fine and other times nothing but the red light of failure
. If it’s a firmware update issue, can you please explain what I need to do that and what the process is? Thanks also for your video on setting the endpoints. I didn’t know that until the second pack!!
