Limitless TP 4070CM SOLDERING GON WRONG HELP!!

[Samu.s]

Hi I have recently soldered the bullets on my tp motor. But some of the tin has spread to my plugs as you can see in the pictures below. Is this very bad or should i not worry ?

 

[King blitz]

I wouldn't worry.

 

[Samu.s]

I wouldn't worry.

Thank you ! And is there a way how to get it off ? Because of it the bullet doesent really fit in my esc

 

[Cypher]

Thank you ! And is there a way how to get it off ? Because of it the bullet doesent really fit in my esc

Think there is some wire thing you can get, for de-soldering
https://www.amazon.com/desoldering-tool/s?k=desoldering+tool

 

[Samu.s]

Think there is some wire thing you can get, for de-soldering
https://www.amazon.com/desoldering-tool/s?k=desoldering+tool

I mean wirhout unsoldering it, is there a liquid or smth with i can gett it off. Just the tin on the bullet i Do you use an iron solder for soldering

 

[dure16]

I’ve had this happen and just ditched the bullet for a fresh one.

 

[King blitz]

Try using some light sand paper .sand it down a little until it fits .tin is conductive so it's not going to hurt .you could use a Dremel with a sanding disk.or just start over and get a new bullet

Did you try to to melt it off with the heat iron? Don't see why it wouldn't

 

[calebgilmore]

you could heat it up with a little butane torch and wick it off

 

[Cypher]

I mean wirhout unsoldering it, is there a liquid or smth with i can gett it off. Just the tin on the bullet i Do you use an iron solder for soldering

https://www.amazon.com/Lesnow-No-Cl...ywords=desoldering+tool&qid=1714223197&sr=8-8

I mean like this. It "sucks" up the tin when heated.

Just lay it over the "liquid" tin.