Fan for kraton 4s with 4274 motor

[danny1202]

Sorry I’m a bit late on this.

I got the stock 6s heat sink fitted, as you can see it needed modify slightly the suit the motor wires, but this leaves some nice drive shaft clearance and with the arrma fan will keep a kind of stock look which is normally my preference.

plus because the heat sink is for a 40mm motor it fits nice and tight on the 4278

 

[Neelis]

Holy poop, do you oil your rigs like it is a bodybuilder that is about to go on stage?!

 

[danny1202]

Holy poop, do you oil your rigs like it is a bodybuilder that is about to go on stage?!

Haha it’s just had a full strip down to change the diff fluids and oil the bearings, but yeah kind of

 

[305HemiGuy]

Sorry I’m a bit late on this.

I got the stock 6s heat sink fitted, as you can see it needed modify slightly the suit the motor wires, but this leaves some nice drive shaft clearance and with the arrma fan will keep a kind of stock look which is normally my preference.

plus because the heat sink is for a 40mm motor it fits nice and tight on the 4278

View attachment 363422

View attachment 363423

View attachment 363424

Nice work!

 

[danny1202]

Nice work!

Cheers mate

 

[6mm Lapua]

Sorry I’m a bit late on this.

I got the stock 6s heat sink fitted, as you can see it needed modify slightly the suit the motor wires, but this leaves some nice drive shaft clearance and with the arrma fan will keep a kind of stock look which is normally my preference.

plus because the heat sink is for a 40mm motor it fits nice and tight on the 4278

View attachment 363422

View attachment 363423

View attachment 363424

Nice! That looks great

 

[6mm Lapua]

Got er mounted! Moves a lot of air, should do the trick.

Had to trim a bit off to make it fit/not hit the center driveshaft.