Typhon Seeking Body Measurements for a Bash buggy project.

[JLspeeddragon]

Ok Arrma Family...
I am in need of some measurements from the Arrma Typhon 6S and 3S..
I am working on a bash buggy build using my Associated RC8B3.2e buggy..
I would like to use the Arrma Typhon body, however I do not know the dimensions of the body / chassis to determine if will fit..
Pics of the needed measurement locations below for reference for the 6S and 3S version.
A. Needing only the body Overall Length.
B & C. Needing front and rear width of only the chassis.
Please state which version your measurements are for (6S or 3S)..
Thank you for your help..
P.S. Can be in inches or Metric, I can work with either

 

[Dan B.]

36x24x34.

 

[Littlemotor]

36x24x34.

But only if she’s 5’2”!

 

[JLspeeddragon]

36x24x34.

LMAO! ok those measurements are definitely not what I was asking for.. and I'm not going to respond to them either in fear of being banned LMFAO!

 

[LibertyMKiii]

36x24x34.

 

[Tex Koder]

36x24x34.

But only if she’s 5’2”!

I dated a girl with those measurements before...
Way way back in the day..

 

[Littlemotor]

I dated a girl with those measurements before...
Way way back in the day..

So did Sir-Mix-Alot… actually I believe her hips were a 36…

 

[Johnny b]

I just measured my 3s typhon. A= 12.5 inches B&C are both 5 &9/16 inches. I'm not a surgeon so I'm not into metric system. Hope this helps. I do watch nip/tuck though.

 

[Relimar]

Typhon 6S. A:13", B&C are both 6.75"

 

[JLspeeddragon]

Typhon 6S. A:13", B&C are both 6.75"

Thank you @Relimar.. I have made note of this and will make some measurements in the morning and go from there