Nomad1981
Active Member
- Messages
- 44
- Reaction score
- 45
- Location
- Bay Area
- Arrma RC's
- Felony
- Kraton 8S
- Kraton 6s
- Kraton EXB
- Mojave EXB
- Notorious
Hi Friends,
Brand new HW xr10 pro. All wired up correctly. When I plug in the battery it starts flashing red fast. I cannot enter calibration mode as when I hold the switch nothing happens. I have servo but no throttle. When I put the servo into the throttle slot in the receiver the throttle controls the servo as a test I ran. Can't turn it off without unplugging the battery. I am running a 3s but the xr10 pro can take up to 4s so I don't see why the 3s would be an issue?
I also have made sure the controller was set to neutral throttle and also made sure it was not in reverse. What could be the problem?
All suggestions welcome please.
Brand new HW xr10 pro. All wired up correctly. When I plug in the battery it starts flashing red fast. I cannot enter calibration mode as when I hold the switch nothing happens. I have servo but no throttle. When I put the servo into the throttle slot in the receiver the throttle controls the servo as a test I ran. Can't turn it off without unplugging the battery. I am running a 3s but the xr10 pro can take up to 4s so I don't see why the 3s would be an issue?
I also have made sure the controller was set to neutral throttle and also made sure it was not in reverse. What could be the problem?
All suggestions welcome please.