IMO....People lose the same left (if looking from front) rear wheel. Its not a Arrma thing, its an RC thing. 1/10th scale RC's have locking nuts holding the wheel on and on top of that it doesn't have the mass to turn that locknut. Now you take a 17mm nut and tighten it up with some locktight and youre good to go...or so you thought. There goes your tire same one every time! If there was equality between the front and rear left, both would keep coming off. The industry in general needs to make the left side (again looking from the front), reverse thread. The reason (imo) the same tire comes off is because the extreme amount of sudden and powerful torque spinning in the way of loosening the nut. The front rarely happens because the front lifts off the ground enough to not put pressure on the nut to undo itself even if its not a wheelie. So much posts on here and Im new to the forum so if this has been discussed before I apologize for bringing it up again. Now this is just my theory and I could be 100% wrong on this but I feel if the left side had reverse thread then tires flying off would be less frequent....???????????????
like the floor fan in your house.
like the floor fan in your house.