Tex Koder
2D , 3D Not a problem. I'll take that Challenge.
Lifetime Premium!
Premium Member
ArrmaForum Fan
Excellence Award
Hospitality Award
Build Thread Contributor
- Messages
- 10,444
- Reaction score
- 26,795
- Location
- Dallas, TX (USA)
- Arrma RC's
- Granite
- Infraction
- Kraton 6s
- Mojave
- Nero
- Senton 3s
- Typhon 6s
- Vendetta
- Thread starter
- #241
I'm thinking the printer gods hate me...
Started this print at about 4am..
(Suppose to be a ~5hr print job)
Should be almost done ,came in to check and found it putting the finishing touches to this...
Suppose to be four carpet spikes / protectors.
I even dried the filament in the dryer -
for over 6 hours the other day....
PETG
235Ā° Nozzle
70Ā° Bed
150mm/s Print speed (50mm/s initial layer)
Started this print at about 4am..
(Suppose to be a ~5hr print job)
Should be almost done ,came in to check and found it putting the finishing touches to this...
Suppose to be four carpet spikes / protectors.
I even dried the filament in the dryer -
for over 6 hours the other day....
PETG
235Ā° Nozzle
70Ā° Bed
150mm/s Print speed (50mm/s initial layer)